Designed not only to heat water quickly and efficiently, but to also deliver every ounce of usable hot water possible from the tank. The electrical system is ignition protected and meets UL specifications. Each heat exchanger is designed for the water heaters capacity. 110 volt, 1400 watt.

Dual Internal Seals and Double Lip Shaft Seal - keep water and dirt out for long life. High Efficiency Motor and High Performance Propeller - give the most flow for your energy dollars. Continuous Duty 120v Single Phase Motors - can run non-stop for years without maintenance. Standard 50'Field Replaceable Power Cords - get you to the middle of the slip without modification. Designed for Harsh Saltwater Environment with Renewable Zinc Anode for Corrosion Protection - thrives in salt or mineral filled water. Easy to Install by One Person - fast setup allows use as a portable unit. Two Year Warranty - for peace of mind.

Motor housing is constructed of 16 gauge 304 stainless steel and bronze endbell for corrosion free operation in fresh or salt water; Motor exceeds NEMA specifications and is UL and CSA compliant, and C.E. certified. Motor shaft is 316 stainless steel, the best material for salt water application. Permanent split capacitor ensures quick high torque and smooth operation, while producing the highest efficiency of a single phase induction motor; Motor and capacitor are matched for ultimate performance. Internal, heavy duty, hard faced mechanical seal with stainless components immersed in dielectric lubricating fluid Additional double lip shaft seal for extra protection. Stator motor windings have double impregnation of baked insulating varnish. Two heavy duty ball bearings provide support for the rotor while being cooled with dielectric type oil. Sacrificial custom designed zinc is provided for conditions where electrolysis may be present.

1700 Series Water Heater

120v
6 Gallon
W/O Engine Heat Exchanger

The "1700 Series" water heater provides hot water for galley and shower. Dense foam insulation provides better and longer heat retention than traditional fiberglass. The tank itself is protected by a 75 PSI T& P ( temperature and pressure) relief valve. The cylindrical design of the tank enables it to withstand more pressure than a cube shaped tank.

Heat exchanger models can be connected to the engine cooling system. This provides the added convenience of hot water when underway or generator power is not available. The innovative heat exchanger is over seven feet in length and is evenly coiled throughout the interior of the tank, providing hot water rapidly and efficiently.

Raritan's water heaters use an ignition protected thermostat. Although it is factory set to 120°F, it is adjustable from 110° to 160°F and has a safety shut down limit of 190°F. All models and sizes have the plumbing connections on the same side to simplify installation. Hot and cold water connections are 3/4" male NPT (National Pipe Thread). Heat exchanger connections are 3/4" female NPT.

Benefits:

• Simple installation - retrofits to most on-board pressure systems
  
• Proven long-life design
  
• Withstands the rigors of the marine environment
  
• Glass-lined steel tank is more durable than stainless steel
  
• Attractive polymer jacket resists corrosion from dampness
  
• Ignition-protected, adjustable thermostat
  
• Round tanks are designed to withstand more pressure than square tanks
  
• Glass-lined steel tank for long life and high efficiency
  
• Environmentally friendly CFC-free foam insulation
  
• Replaceable magnesium anode to protect tank and neutralize acids in the water
  
• The tank is covered by a five-year Limited Warranty
  
• Each unit is assembled by hand, individually tested and backed by Raritan's two-y